GDR TECH HOUSTON GARAGE DOORS REPAIR

How To Clean Garage Door Sensors

    When it comes to a garage door repair in Houston, Call an expert. Our technicians are ready to take your call.

    ☎️ (281) 214-9264

    Or, fill out the form.

    How To Clean Garage Door Sensors

    Garage door sensors are an essential safety feature of your garage door system. They detect obstructions in the path of the door, preventing accidents and damage. Over time, dirt and debris can accumulate on these sensors, reducing their effectiveness. In this article, we’ll guide you through the process of cleaning garage door sensors to ensure they continue to work efficiently.

    Identifying Garage Door Sensors

    Garage door sensors are typically found near the bottom of your garage door tracks, about 4-6 inches off the ground. They consist of two small devices – one on each side of the door – that communicate with each other using an infrared beam. When the beam is broken, the sensors send a signal to the garage door opener, stopping the door from closing.

    Gathering Cleaning Materials

    Before you start, gather the following materials:

    • A soft cloth or microfiber towel
    • A mild cleaning solution, like warm water mixed with a few drops of dish soap
    • A small step ladder or sturdy stool

    Cleaning The Sensors

    1. Turn off the garage door opener: To ensure your safety, disconnect the garage door opener from the power source before you begin cleaning the sensors.
    2. Inspect the sensors: Look for any visible dirt, debris, or cobwebs on the sensor lenses. If you see any obstructions, gently remove them with a soft brush or cloth.
    3. Clean the lenses: Dampen the cloth with the cleaning solution, and gently wipe the lenses of both sensors. Be careful not to scratch or damage the lenses during this process.
    4. Dry the lenses: Using a dry section of the cloth, gently remove any remaining moisture from the sensor lenses.
    5. Test the sensors: Reconnect the garage door opener to the power source and test the sensors by closing the garage door. If the sensors are functioning correctly, the door should stop and reverse when you break the infrared beam with your hand or an object.

    People Also Ask

    How often should garage door sensors be cleaned?

    It’s a good practice to clean your garage door sensors every three to six months, or more frequently if you live in a dusty environment. Regular garage door maintenance can help keep your sensors in optimal condition.

    Why is my garage door not closing even though the sensors are clean?

    If your garage door still won’t close after cleaning the sensors, the issue may lie elsewhere. Check for misaligned sensors, damaged wires, or broken garage door opener. If you’re unsure, it’s best to call a professional for assistance.

    How do I realign garage door sensors?

    To realign garage door sensors, loosen the mounting brackets and adjust the sensors until the LED indicator lights on both devices are solid. You can find more detailed instructions in this guide on aligning garage door sensors.

    Can I replace garage door sensors myself?

    Yes, replacing garage door sensors is a relatively simple task that you can do on your own. However, if you’re not comfortable working with electrical wiring or need help with the process, it’s always best to contact a garage door repair specialist.

    In Conclusion

    Regularly cleaning your garage door sensors can significantly improve their performance and extend their lifespan. By following the steps outlined in this article, you can ensure that your garage door sensors remain in good working condition and continue to provide essential safety features for your home. Remember to periodically inspect and clean the sensors, and address any issues promptly to prevent potential accidents or costly repairs. With proper care and maintenance, your garage door sensors will serve you well for years to come.

    5/5 - (1 vote)
    Contact Us
    COVID-19 NOTICE:
    Our technicians are equipped with masks and gloves complying with health and safety regulations.
    This is default text for notification bar